Grove WiFi ESP8266 Board

$13.95

QTY:

Description

The Grove Wifi ESP8266 board is a serial transceiver module featuring the ubiquitous ESP8266 IoT SoC. With integrated TCP/IP protocol stack, this module lets your microcontroller interact with WiFi networks with only a few lines of code. Each ESP8266 module comes pre-programmed with an AT command set firmware, meaning you can send simple text commands to control the device. The SoC features integrated WEP, WPA/WPA2, TKIP, AES, and WAPI engines, can act as an access point with DHCP, can join existing WiFi networks and has configurable MAC and IP addresses.

 

Features

  • Grove 4-pin connector (RX,TX,VCC,GND)

  • 802.11 b/g/n protocol (2.4GHz)

  • WiFi Direct (P2P), soft-AP

  • Supports three modes: AP, STA and AP+STA coexistence mode

  • Integrated TCP/IP protocol stack

  • LwIP (lightweight IP)

  • Integrated low power 32-bit CPU could be reprogrammed as an application processor

  • Integrated temperature sensor

  • Serial UART Interface

  • Multi-queue QoS management

  • Wake up and transmit packets in < 2ms

  • Metal shielding

  • Onboard ceramic antenna

  • Reset switch

 

Specifications

  • Input voltage: 3V / 5V

  • Baud Rate: 115200

  • Based on ESP8266 ESP-07 SoC

  • AT Firmware: esp_iot_sdk_v1.1.0 + Seeed modifications:

  • 2x additional AT commands to control blue Link LED.

  • Register red WiFi LED to the ESP8266 wifi state LED.

  • AT command set

  • SDIO 1.1/2.0, SPI, UART

  • Five power states: OFF, DEEP_SLEEP, SLEEP, WAKEUP and ON.

  • Standby power consumption of < 1.0mW (DTIM=3)

  • Integrated TR switch, balun, LNA, power amplifier and matching network

  • Integrated PLLs, regulators, DCXO and power management units

  • +19.5dBm output power in 802.11b mode

  • Power down leakage current of<10uA

  • Hardware accelerators for CCMP (CBC-MAC, counter mode), TKIP (MIC, RC4), WAPI (SMS4), WEP (RC4), CRC

  • WPA/WPA2 PSK, and WPS driver

  • A-MPDU & A-MSDU aggregation & 0.4ms guard interval

  • Dimensions: 25.43mm x 20.35mm

 

This part comes pre-programmed  with the AT Command set but can be reprogrammed with your own code.

How to use the AT Command Set

Check out this SwitchDoc Labs Posting on using the AT Command set on the ESP8266.

YOU MAY ALSO BE INTERESTED IN THE FOLLOWING PRODUCT(S)